SALIENT FEATURES

• CONFORM to IS 4985 & IS 13592
• HIGHER FLOW : compare to GI, AC & CI Pipes due to smoother internal surface
• ENERGY SAVING : Low friction loss ensures lower pumping cost.
• LIGHT WEIGHT : make them easy to store, handle, transport and Install.
• SEAMLESS : make them health friendly avoid contamination of the fluid running in it.
• DURABILITY : they last longer
• RESISTENCE : to chemical reactions,electrolytic, corrosions.
• ODORLESS : Ensures hygenic conditions for portable water.
• ECONOMICAL : Almost Zero maintenance as free from rust, scale, formations & unharm by moisture.
• IDEAL SUBSTITUTE : To CI, GI & MS Pipes at almost 40% cost.

TECHNICAL DATA

• SPECIFIC GRAVITY : 1.4 to 1.45 gm/cm³
• THERMAL CONDUCTIVITY : 4 x 10⁴Cal./Hr.Cm²/⁰ C/Cm.
• IMPACT STRENGTH : 3Kg/Cm² at 20⁰C.
• HEAT REVERSTION : Less than 4%
• WATER ABSORPTION : Less than 4mg/Cm²
• CO-EFFICIENT OF LINEAR EXPANSION : 5 to 8.5x10^-5 m/m/⁰C
• TENSILE STRENGTH : 50 +- 5Mpa
• ELECTRICAL RESISTENCE : 10¹⁴ Ohm.Cm.
• MODULUS OF ELASTICITY : 2800 +- 200 Mpa
• VICAT SOFTENING TEMPERATURE : More than 80⁰ C

TYPICAL APPLICATIONS OF KAMAL PVC PIPES

• Portable / Drinking Water Supply, Lift irrigation, Sprinkle and drip irrigations.
• Tube Well, Borewells and hand pump casing.
• Sewerage, Waste and ain Water System (SWR) system.
• Plumbing & Sanitary System.
• Cable Ductings and electrical conduits.
• Air Conditioning and Industrial ductings.
• Garbage ducting systems.
• Rain Water harvesting Systems.
• Gober / Biogas plants.
• Chemical plants & processing plants.
• Industrial effluent disposals.
• Water Treatment Plants.
• Subsurface Drain pipes used in underneath road in Highways & Roadways.

HANDLING & INSTALLATION OF KAMAL PVC PIPES

• For laying & installation of Kamal PVC Pipes refer IS:7634 (PART III) : 1975
• Pipes should be kept on an even surface, should be properly supported & should be stacked only upto height of 1.5. MT. while storing.
• Provisions should be made for expansion joints, air events and proper anchorage, while laying longer pipelines. Exposed to sun lights and unevensurface is not desirable.
• Underground pipes should be laid about 60 to 100 cms. below the ground level. Trench should be as narrow as possible and its bottom should be free of stones, sharp objects etc. Preferable sand bedding may be provided.
• PIPE OR FITTINGS SHOULD NOT BE CLEANED WITH SOLVENT CEMENT.
• Solvent Cement should be takeb out of container only in required quantities and it should be closed immediately. Very old, hard semi-fluid solvent cement should not be used.
• A water tap should not be directly fixed on a PVC Pipe. A service saddle should be used and proper anchorage should be provided.
• Threaded PVC Pipes & Fittings should not be over tightened, as threads may get damaged.